Jeep Logo Floor Mats @ JC Whitney Auto Parts store
Jeep Logo Floor Mats
JEEP� FLOOR MATS For all Jeep� vehicles Rubberized vinyl with red Jeep� name molded in (won't wear or wash out) Nibbed backing holds mats in place Protect carpeting and personalize interior. Remove quickly for easy cleanups. Approximately 18" x 26". Sold in pairs. Applications: Jeep All Models, Jeep All Models, Jeep All Models, Jeep All Models, Jeep All Models, Jeep All Models SKU: 47ZX3953B
JSP ThunderTail Rear Wings
THUNDERTAIL� REAR WING For trucks Mounts to bed rails or flat fiberglass tonneau cover to dress up truck's exterior Includes built-in 31" super-wide LED brake light The hottest new look for your sport truck! 9-1/2" tall wing made of fiberglass with gray primer finish can be painted to complement exterior color or designs. Drilling is required for installation. Mounting hardware and easy-to-follow instructions included. Note: Test wing prior to painting and installation for size, fit and possible obstructions (locks, latches, locking pins, etc.). To ensure the proper wing size, measure the width across the flattest area of the fiberglass cover (see diagram at left for measurements identified below). NOTE: SKU numbers ending in E are freight shipped from JC Whitney warehouse by truck/air freight. A: Outside edges of pedestals. B: Inside edges of pedestals. C: Bolt to bolt. D: Pedestal length. Applications: All Makes All Models SKU: 47ZX2137TE
Jacobs Electronics Performance Ignition System Kit
PERFORMANCE IGNITION SYSTEM KITS Kits combine the best performance, power, precision and control in one super-tough package! The best-bang-for-your-buck ignitions ever offered! Deliver up to 10,000 RPM for 8-cylinder vehicles, up to 20,0000 RPM for 4-cylinder vehicles with NO HIGH-END DROP OFF! Systems ensure the most complete and sustained ignition for easier starts, stronger pulling, lower ETs, smoother idle, reduced plug fouling and crisper throttle response. Capacitive discharge ignitions with HEXFET solid-state firing technology and silicone-controlled rectifiers provide consistent, reliable and stable multisparking across 22? of crankshaft rotation?the spark interval stability of these analog ignitions are superior to most digital ignitions. Perfect for race classes that prohibit digital engine controls. All circuits are encapsulated in a high-tech composite material to protect against extreme g-load impacts, hard acceleration and temperature extremes. Kits can be submerged in water for long periods. Special internal filters and low internal RFI reflectivity of the aluminum housing eliminate interference and line noise common to other ignitions. With connections for mag pick-up triggers, dedicated tachometer/EFI output lead and conventional input signal lead. All supply leads are soldered for maximum strength and corrosion resistance and feature built-in over-current protection. For 12-volt negative-ground systems. Due to the extremely high output of these systems, Jacobs recommends use of the C-4 coil (sold separately) to prevent overloading original-equipment coil. Applications: All Makes All Models SKU: 47ZX4517U
Longhorns Custom-fit Cargo Tie-downs
LONGHORNS CUSTOM-FIT CARGO TIE-DOWNS Save 20% ! Strongest! Fastest to install! Easiest to use! Fit into existing stake holes in pickup Marine-like cleat acts as anchor for strap or rope (not included) Stronger and greater load-bearing capacity than clamp-on tie-downs! Strong heat-treated aluminum alloy. Patented design eliminates the need to tie your straps/ropes through rings, which can result in slippage and cargo shift or knots. Set of 4. Quantity is limited. Not all styles, sizes or colors shown may be available. Applications:1988-2002 GMC C/K Pickup,1988-2002 Chevrolet C/K Pickup,1988-2002 GMC C/K Pickup,1988-2002 Chevrolet C/K Pickup SKU: 48ZX5671X
