High-Current & Standard Converters @ JC Whitney Auto Parts store
High-Current & Standard Converters
CONVERTERS Operate 12-volt negative-ground accessories in vehicles with a 6- or 12-volt positive or 6-volt negative-ground system. Converter is small�1-3/4" cube� and light�about 9 oz.�fits easily on the accessory it serves or behind your dash. Uses common ground; no isolation required. Reverse polarity, overload and short-circuit protection. Low (10 mA) no-load current minimizes draw on battery when an alarm system or radio/clock with memory is in use. Please note: Check continuous and peak power requirements before ordering. 1) With your vehicle's 6-volt input and these inverts/converts, a high-output 12-volt sound system may perform effectively at low volume but not for extended periods beyond the converter's stated capacities. 2) Output is reduced by weak batteries, malfunctioning electrical systems and poor connections. Not recommended for: power-actuated door locks, trunk release solenoids, air conditioner clutches, fans, blowers, power windows or other electromechanical devices. Available: high-current and standard converters for positive- to negative-ground; high-current and standard converters for negative- to negative-ground. Applications: All Makes All Models Manufacturer: Folia Tec SKU: 81ZX3905R
High-Power Woofers
HIGH-POWER WOOFERS White polypropylene cone is super resistant to sun, dust and moisture damage Heat-resistant Kapton voice coil Specially-treated white foam-edge suspension Vented strontium magnet structure. Bumped yoke plate. 4-ohm impedance. Click on item SKU# for additional information. Applications: All Makes All Models Manufacturer: Hella SKU: 81ZX5139T
Grille Insert
BILLET ALUMINUM GRILLE INSERT SET Corrosion-resistant billet aluminum inserts are polished to a high luster Black powder-coated trim adds bold contrast Inserts install easily into standard grille openings�no drilling required Make your Wrangler stand out from the chrome crowd! Hardware and instructions included. Applications:1987-1995 Jeep Wrangler,1987-1995 Jeep Wrangler,1987-1995 Jeep Wrangler,1987-1995 Jeep Wrangler SKU: 47ZX4682W
Hidden Hitch Draw-bar & Bumper-mount Bike Carrier
DRAW-BAR BUMPER-MOUNT BIKE CARRIERS 2 mounting options?carriers mount to draw bar of your trailer-hitch receiver or on your step bumper Great if you don't have a receiver or need it for towing Carriers keep bicycles safely away from vehicle's painted finish Locking top plate secures bikes. Heavy-duty steel with tough, textured gloss black powder-coat finish. Rounded corners?no sharp edges to cut or scratch. Carriers mount and remove easily?no need for assembly or disassembly. Lock in place using your hitch ball or hardware kit (sold separately). Folding model allows for trouble-free access to rear of vehicle. Applications: All Makes All Models, All Makes All Models SKU: 47ZX8195N
Gear Reduction Starter
PERFORMANCE GEAR REDUCTION STARTER Ends all hot start problems�forever! One year manufacturer warranty Get total starting power! Far superior to original equipment. 100% more torque�4.4:1 gear reduction, roller bearing support and integrated solenoid ensure this starter can crank any engine, no matter how high its static compression. 200% more cranking power. More starts�20,000 starts vs. 5,000 for stock. Uses less amperage. Turns faster under load, slower under no load and is more cold-weather resistant. Enhanced rock/hill climbing ability with clutch-free starting. 1/3 smaller size and weight for easy installation. Heavy-duty construction and extreme reliability are the primary hallmarks of this performance gear reduction starter. Five sealed ball bearings increase efficiency, reduce wear and thrive under extreme conditions, like water intrusion. Integral solenoid is corrosionproof and heat-sinked to prevent overheating and thermal breakdown. Stainless steel mainshaft provides direct line engagement, which increases even further efficiency, power and reliability. Also, the rotating billeted aluminum nose cone adapter can be turned in 20� increments (depending on application) to clear headers, oil pans or other obstacles. Depending on application there are dual-bolt patterns so they fit both the 153-tooth and 168-tooth flywheels. PSI certified and approved. All applications are for gas engines except where noted. Applications: Ford All Models 8-cyl big block 352; 360; 390; 406; 410; 427; 428 SKU: 81ZX5816W
