GENERIC/TOOLS/EXHAUST TOOLS @ JC Whitney Auto Parts store
GENERIC/TOOLS/EXHAUST TOOLS
LISLE� TAILPIPE EXPANDERS Designed to remove clamp grooves and round out pipes more easily than ever! Made of extra-strong materials�use safely with your impact wrench. Grade 8 steel bolt. For all cars, trucks, buses. 2 choices: 1-5/8" to 2-7/16" (41.3-61.9mm) (of malleable iron); or 2-3/8" to 3-1/4" (60.3-80.9mm) (of malleable iron/aluminum). Applications: All Makes All Models Manufacturer: STR SKU: 12ZX4210X
High Lift Front Coil Springs
HIGH-LIFT FRONT COIL SPRINGS A safety must for heavy-duty or off-road use! Approx. 10 to 20% stiffer than stock coils Built to survive the worst conditions. Perfect for additional front-end lift on trucks with snow plow or winch�or to replace worn, sagging springs, etc. Hot-rolled, hot-wound, stress-relieved steel is epoxy coated to resist corrosion. Available with lift indicated to level or raise vehicle. Installation may require realignment of front end. Sold in pairs. NOTE: SKU numbers ending in F are factory shipped and may take a little longer to reach you. (A) Also includes one pair of bronze camber/caster alignment bushings (front-end alignment corrections cannot be made with stock bushings when high-lift springs are installed). Applications:1993-1998 Jeep Grand Cherokee Wheel Drive: 4WD SKU: 50ZX1647W
Heavy-Duty Automatic Battery Isolators
BATTERY ISOLATORS Run accessories in vehicle without draining battery Automatically charges auxiliary battery as you drive, never overcharges Self-contained electrical system converts alternator or generator to safe, efficient charger Automatically isolate both the auxiliary and vehicle batteries so the discharge of one does not drain the other's power. Handle alternators up to 160 amps. Rectifiers and heat sink allow maximum heat dissipation without mechanical attachment. Eliminate shorting problems. Solid state. For all 6- to 36-volt, negative-ground electrical systems. UL listed. Choice of 2-battery systems (one vehicle battery and one auxiliary) and 3-battery systems (one vehicle battery and 2 auxiliaries). Choose isolators, connector kit, and emergency start battery isolator. Applications: All Makes All Models SKU: 12ZX9421N
Grizzly Overrider Bars
"THE BIG GUYS" OVERRIDER BARS Big 3" diameter tubing is a distinctive styling bonus for your front bumper Specially designed for use with double-tube front bumpers (sold separately) Smaller bars simply can't compare to the difference these "big guys" will make on your Jeep?! Modular (not welded together) design simplifies installation and makes it easier to replace a damaged bar. Bars bolt to factory frame holes. No drilling required. Detailed instructions and installation hardware included. Shipped separately from factory. Cannot be shipped express. NOTE: SKU numbers ending in F are factory shipped and may take a little longer to reach you. Applications:1986-1996 Jeep Wrangler YJ,1986-1996 Jeep Wrangler YJ SKU: 47ZX7189RF
Gear Reduction Starter
PERFORMANCE GEAR REDUCTION STARTER Ends all hot start problems�forever! One year manufacturer warranty Get total starting power! Far superior to original equipment. 100% more torque�4.4:1 gear reduction, roller bearing support and integrated solenoid ensure this starter can crank any engine, no matter how high its static compression. 200% more cranking power. More starts�20,000 starts vs. 5,000 for stock. Uses less amperage. Turns faster under load, slower under no load and is more cold-weather resistant. Enhanced rock/hill climbing ability with clutch-free starting. 1/3 smaller size and weight for easy installation. Heavy-duty construction and extreme reliability are the primary hallmarks of this performance gear reduction starter. Five sealed ball bearings increase efficiency, reduce wear and thrive under extreme conditions, like water intrusion. Integral solenoid is corrosionproof and heat-sinked to prevent overheating and thermal breakdown. Stainless steel mainshaft provides direct line engagement, which increases even further efficiency, power and reliability. Also, the rotating billeted aluminum nose cone adapter can be turned in 20� increments (depending on application) to clear headers, oil pans or other obstacles. Depending on application there are dual-bolt patterns so they fit both the 153-tooth and 168-tooth flywheels. PSI certified and approved. All applications are for gas engines except where noted. Applications: Ford All Models 8-cyl big block 352; 360; 390; 406; 410; 427; 428 SKU: 81ZX5816W
