Just mount the 4" x 6" x 1" thick base in your bench vice and you're ready to bend solid round stock up to 3/8", and square up to 1/2". The stout 7/8" diameter 16" long handle makes bending easy. Included dye assortment produces 3/8", 3/4", 2", 3", and 4" diameter bends. Coils and bends wires of many sizes too. Made in the USA. One Year Limited Manufacturer's Warranty. SKU: 28100 Category: Metal Shop Fabrication Bending
Round Hole Punch 1 Inch
The quickest, easiest way to put large, burr-free holes in sheet metal (up to 16 gauge). Just drill a starting hole, insert punch, then thread die on opposite side and turn with Allen wrench (not included). Made in England with heat treated steel. SKU: 28027 H Category: Metal Shop Fabrication Punching
Hotcoat 20 Pak 6" hooks
It's always best to use clean, uncoated metal hooks to suspend parts for powder coating and curing. Sold in packs of 20, each "C" shaped,.059: thick hook supports up to 10 lbs. SKU: 58111 Category: HotCoat Powder Coating Powder Coating Equipment Powder Coating Accessories
Buff Bob Set Cones And Cylinders
Mounted on sturdy steel shanks, these felt buffing bob assortments really get into the tight spots. Great for putting the final touches on inticate pieces where larger buffs simply will not reach. All are made of long-lasting hard felt and will work well with any of the buffing compounds. Great for cleaning out residue left from buffing. A perfect accessory for the Foredom Craft Kit (#13028 and #13005). The small 1/8" shank sets are ideal for trim and the 1/4" shank set is great for engine component buffing. Max. 15,000 rpm. SKU: 13055 Category: Metal Buffing & Finishing Buffing Motors/Accessories
Professional Battery Load Tester UL Approved
Battery Load Tester - Test the true condition of your battery by testing it under load. This tool applies an electrical load to simulate actual use conditions. Tests 6v/12v lead acid batteries. Compact steel case incorporates handle, and clamp holders. Testing can be done with engine running on most vehicles. Imported. SKU: 25116 Category: Performance and Tune-Up Electrical & Diagnostic Diagnostic Testers
Detail Gray Paint Aerosol 13 oz
This Detail Paint is specially formulated to duplicate the original look of die cast and stamped steel. Protected up to 250 degrees F by this paint, metal parts will keep that brand new look for a long time. Available in aerosols and quarts. One aerosol covers 6 sq.ft., one quart covers 50 sq.ft., acrylic lacquer, natural low 4-15% gloss. Great on alternator and distributor housings. Buy 3 or more, mix and match, and SAVE! SKU: 10036 Z Category: Specialty Coatings UnderHood Coatings Metal Finishes
